Antec SKELETON Instrukcja Użytkownika

SKELETONUser’s Manual

8Connecting the Front I/O Ports3.1 USB 2.0 PortsConnect the front I/O panel USB cable to the USB header pin on your mother-board. Check the motherboar

93.4 AC’97/HD Audio PortsConnected to your front I/O panel there is an Intel® standard 10-pin AC’97 connector and an Intel® 10-pin HDA (High Definitio

10Cooling System4.1 The Super Big Boy 250mm Multi-LED FanThe Skeleton’s unique and innovative open case design provides that only one Super Big Boy 25

114.3 Removing the 92 mm Hard Drive FanEnsure that the fan power cable is disconnected before removing the fan. 1. While facing the front of the cas

Antec, Inc.47900 Fremont Blvd.Fremont, CA 94538USAtel: 510-770-1200fax: 510-770-1288Antec Europe B.V.Stuttgartstraat 123047 AS RotterdamThe Netherland

Table of ContentsIntroduction1.1 Case Specifications………………...……………...…………… 21.2 Diagram……………………………………………...…...……… 21.3 How to Carry the Skele

1At Antec, we continually refine and improve our products to ensure the highest quality. As such, it’s possible that your new case may differ slightly

21.1 Case SpecificationsCase Type Open Case DesignColor Metallic SilverDimensions 13”(H) x 14.8”(W) x 16.5”(D) 33.02 (H) x 37.6 cm (W) x 41.9 cm (D)We

31.3 How to Carry the SkeletonThe Skeleton case is designed to be held by either set of grips on the top of the side railing. Use these handles when m

42. To completely remove the Component Tray from the Frame, find the release tab on the lower left side of the Component Tray when the Tray is fully

53. Place the motherboard on the brass standoffs. Screw in the motherboard to the standoffs with the provided Phillips-head screws.Replace the Mothe

63. Slide the plate-mounted power supply into the bottom level of the Component Tray until it locks into position. There are two possible locations

74. Connect the data and power connectors from the motherboard and power supply to the device.Note: It may be necessary to remove the motherboard tr