Antec II Instrukcja Użytkownika Strona 9

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 10
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 8
To install the 80mm VGA fan:
1. Remove the two screws holding the silver metal stripe to the air inlet that connecting to the
Tube of the ACAG. Set the parts aside.
2. Remove the two black screws holding the plastic panel to the ACAG.
3. Carefully remove the plastic panel from the ACAG by lifting upwards near the tabs.
4. Carefully use your fingers to detach the tabs holding the 80mm fan cap to the panel.
5. Install the 80mm fan to the fan opening so that the air is blowing into the VGA card. Secure
the fan with screws.
6. Replace the plastic panel and fan onto the ACAG by pressing down around the tabs. You will
hear them snap into place.
7. Replace the screws from steps 1 and 2.
Maintaining the Washable Air Filter
There is a washable air filter behind the front bezel. Tilt the case backwards so you can use you
fingers to squeeze the two tabs on the filter to remove it. We recommend washing the air filter as
often as required by environmental conditions, at least once a month initially. Failure to keep the
installed air filter clean will result in higher system temperatures and possible stability problems.
From time to time it will be necessary to wash the installed air filter. The frequency will change
depending on system usage (users whose systems run 24/7 will likely have to check/wash more
often than those who don't use their systems every day) and on environmental conditions.
The double Hinge Door
This case comes with a double hinge door that can open 270 degrees so it will be parallel with the
side panel for easy access. In case you need to remove the door:
1. Open the door to 90º, and gently press the small plastic tab on the upper hinge. Tilt the door
away from the upper hinge pin, then lift the door off the lower hinge pin. Set the door aside
in a safe place.
2. To replace the front bezel double hinge door. Place the lower hinge slot over the lower hinge
pin and press or rotate the top of the door in so that the tab fully engages with the upper hinge pin.
9
Przeglądanie stron 8
1 2 3 4 5 6 7 8 9 10

Komentarze do niniejszej Instrukcji

Brak uwag